In article ,
Matt Zach wrote:


That is what someone else told me, but Delta said no...... I hope you are
correct, because I would be extremely happy with the Delta. Is there something
that I can challenge Delta with, to have them reconsider their statement that
'this shaper will not work with any phase converter' ??

Ask them if that applies to the rotary phase converters at the electric utility
power _generating_ facility.

Then ask what the difference is between _that_ phase converter, and an
on-site motor-generator set configured as a rotary phase converter.

The response should be entertaining. evil grin



Thanks, Jim !

Jim Wilson wrote:

Matt Zach wrote...
I was ready to buy the DELTA SLIDING TABLE SHAPER MDL. 43-792 ( 7 1/2 HP
3 phase ), when I found out that Delta claims that it will not run with
a phase converter.

Whaaat??! Maybe not with some static converters, owing to the power
capacity drop, due to the missing leg. However, a balanced 10HP rotary
converter would *have* to work, unless the laws of physics have changed
lately.

Cheers!

Jim