Have you tried the primer yet. I would think that the primer by
itself might do the trick. It's job is to clean the pipe.



On Apr 19, 2:57*am, "Bob F" wrote:
Oren wrote:
On Sat, 18 Apr 2009 16:10:18 -0400, "MiamiCuse"
wrote:

I have a section of PVC pipe I need to put a ball valve in. *The
pipe was previously painted (I believe water based paint) and I need
to clean that paint off so I can apply PVC primer and glue. *What is
the best way to clean the paint off? *I tried sandpaper and that did
not go very far,

Thanks,

Acetone?

Acetone will definately disolve the PVC.