"Arfa Daily" wrote in message
news

"John Keiser" wrote in message
news:yYidnTRev8b_ZyvUnZ2dnUVZ_gKWnZ2d@hawaiiantel. net...
On square and round belts, I've had surprisingly good, longlasting
results with crazy glue, a clean razor blade and a teflon v-block. On
flat belts, your stitch method may be the best.

--
Remove -NOSPAM- to contact me.


Likewise, similar success. A good quality cyanoacrylate glue does an
excellent job on 1.2mm square section cassette belts. As John says though,
it is necessary to get a very clean and perpendicular cut at the two faces
to be joined. Once the joint has been made, a piece of very fine wet and
dry paper can be used to remove any glue that has exuded from the joint.
This can be done with the belt stretched over your finger. If you are
successful, the joint is barely visible without magnification, and will
stand a substantial 'stretch' test

Arfa



I remember when Superglue first came onto the market, there was a TV advert
campaign where a bloke sliced a (fairly hefty) round section rubber belt in
half, then superglued it back together. A few seconds (apparently) later he
stretched it between a pair of parallel bars (gymnastic equipment) and then
sat and bounced on it without falling onto his arse. Quite impressive, if
it wasn't faked.



Gareth.