On 30 dic 2008, 15:46, "Arfa Daily" wrote:
"b" wrote in message

...

I have a late '80s vintage Philips CP110 Tv , which works well, but
the colour is weak, even with the saturation control set to full the
picture is only just more 'colourful' than B&W!
. is this likely to be something like a low voltage to the RGB
stage,or something more serious?

-B

If the A1 control is set wrongly, some of the older CRT types can look
'washed out'. Sometimes, beam limiter problems can give the same effect. A
fault in the ACC circuitry will do it, and sometimes, a mishapen sandcastle
pulse, which used to be quite common back then. Often down to a resistor in
the HOP stage, where the pulse is 'constructed', having gone high.

Arfa

I finally dug this set out again today and it did seem as if the G2
was a bit high, so I lowered the SCREEN control slightly on the Line o/
p tranny and that gave a far more natural colour. Haven't tried it
with RGB source, as didn't have one to hand. set seems fine now ,
cheers,
B.