On Tue, 27 Jan 2009 16:40:55 UTC, "ARWadsworth"
wrote:


"Tim S" wrote in message
...
Distorted Vision coughed up some electrons that declared:

I'm in the process of replacing some of the switches and surface
moulded boxes in our house for cosmetic reasons. Some of the switches
are really dirty, scratched etc and some the moulded surface boxes are
cracked etc.

Anyway I have a question and I know its going to sound really stupid
to alot of you. But what is the best of breaking the knockouts on the
moulded boxes to ensure clean straight edges. The first one I tried I
used a pair of plier but it was a bit of a mess - good job they are so
cheap.
Am I missing something here. Is there a recommended way.

Many thanks!

Not stupid at all...

My amateur trick is to slice with sides with a junior hacksaw, snap out
with
pliers, punch the inner skin with a screwdriver (if applicable) and finish
with a few strokes of a 1/4" full size coarse square file through the lot.
Usually the knockouts do not need to look perfect as they are covered by
trunking. I use my wirecutters to break the knockouts. If the knockout needs
to look good then it is hacksaw time.

Dremel.
--
The information contained in this post is copyright the
poster, and specifically may not be published in, or used by
http://www.diybanter.com