Small engine rebuild update.
On Tue, 13 Jan 2009 23:25:11 -0600, the infamous Andy Asberry
scrawled the following:
On Tue, 13 Jan 2009 06:02:19 -0800 (PST), stryped
wrote:
On Jan 12, 9:39*pm, "Greg O" wrote:
"stryped" wrote in message
Also, I mixed up the lifters as they fell out before I could figure
out which one went with which lifter. They have no itendifiable
marking on them.
If you got those in the wrong hole, the valves are NOT adjusted.
I appreciate your help. This is my first rebuild and I want it to be
a sucess but I am tempted to go down to the harbor freight store and
buy that 6 horse engine for 160 bucks!
Check your engine shaft diameter. I think it is 7/8" . That 6.5 hp at
harbor Freight has a 3/4.
Does anyone make adapters for small incremental shifts in shaft size
such as this?
--
A great preservative against angry and mutinous thoughts, and all
impatience and quarreling, is to have some great business and
interest in your mind, which, like a sponge shall suck up your
attention and keep you from brooding over what displeases you.
-- Joseph Rickaby
|