On Wed, 31 Dec 2008 16:38:29 -0800 (PST), rodjava
wrote:

On Dec 31, 3:52*pm, Jon Elson wrote:
rodjava wrote:
I order this 16mm indexable tool holder set at but haven't received it
yet.

http://www.tools4cheap.net/proddetai...prod=carb7pclg

I need your help to translate the last numbers to this indexable tool
holder and insert.

Holder SSRCR1616H09
Insert SCMT09T308

It appears from the pic that there are 3 diamond inserts and two square
ones. *Also, the diamond at the far right is a different size than the
other two. *I can't tell much about the far left holder, although I'm
guessing it has a triangular insert with no center hole. *The next one
to it looks like it has a sawed-off brazed bit, maybe. *So, it appears
to have 5 different inserts in the set.

Jon

Jon,
Thanks.
I think the last number are different from the ANSI chart because they
might be metric. This is just a guess. I was hoping to know what
size insert it was as well
as the thickness and radius.

Rod


SCMT09T308

S=Square insert
C=7 degree relief
M=5 thou tolerance on thickness; 2 thou tolerance on inscribed circle
T=Partly cylindrical hole,Single sided chip breaker/insert
09=3/8" inscribed circle/9mm cutting edge length
T3=5/32" thick
08=1/32" corner radius.

Taken from the J&L catalogue

HTH
Mark Rand
RTFM