"Morris Dovey" wrote
Started with a rectangular block, nibbled off the corners, drilled 2
holes through the adjacent edges, then drilled the large hole...
Here you go, Bro ... make a cylinder "component" with diameter of the hole
you want, poke it though the curved surfaces where you want the hole(s),
then use the "intersect with model" function, then erase the parts you don't
want.
When you know how, it takes longer to draw the box and cylinder than to get
holes in the curved surfaces ... about a three minute job.
--
www.e-woodshop.net
Last update: 10/22/08
KarlC@ (the obvious)