Michael
For a look at what the Taig is capable of, at least in the hands of a genius
like John Bentley, go to his site he
http://www.jrbentley.com/

see also the mods he made to a BusyBee lathe...just beautiful!

Peter M



"Michael Koblic" wrote in message
...
The continuing saga of a miser looking for a "wonderlathe":

1)
http://www.leevalley.com/wood/page.a...330,50260&ap=1

I have a motor and lots of 1/4" tools of uncertain provenance. Would need
a chuck for the headstock and probably compound slide from this selection:

http://www.leevalley.com/wood/page.a...330,50260&ap=1

I have heard good things about this. It would take care of small parts
(steel, 3/4" diameter). I am not sure how specialized and therefore
obtainable the parts are.


2) http://busybeetools.ca/cgi-bin/picture10?NTITEM=B1979C

The apparent cost is over double of the Taig, but it comes with a motor, a
compound, 3-jaw chuck etc. which closes the dollar gap considerably. Lower
speeds, therefore almost three times the diameter can be handled, screw
cutting, auto feed etc.

The nearest mini is $200 more. Why, oh why, the short distance between
centres?

All in all, it seems that No.2 will do everything the No.1 will and much
more for a slightly greater sum. Does this make sense?

--
Michael Koblic,
Campbell River, BC