Posted to rec.crafts.metalworking
|
|
Which would you choose?
Michael Koblic explained :
The continuing saga of a miser looking for a "wonderlathe":
1) http://www.leevalley.com/wood/page.a...330,50260&ap=1
I have a motor and lots of 1/4" tools of uncertain provenance. Would need a
chuck for the headstock and probably compound slide from this selection:
http://www.leevalley.com/wood/page.a...330,50260&ap=1
I have heard good things about this. It would take care of small parts
(steel, 3/4" diameter). I am not sure how specialized and therefore
obtainable the parts are.
2) http://busybeetools.ca/cgi-bin/picture10?NTITEM=B1979C
The apparent cost is over double of the Taig, but it comes with a motor, a
compound, 3-jaw chuck etc. which closes the dollar gap considerably. Lower
speeds, therefore almost three times the diameter can be handled, screw
cutting, auto feed etc.
The nearest mini is $200 more. Why, oh why, the short distance between
centres?
All in all, it seems that No.2 will do everything the No.1 will and much more
for a slightly greater sum. Does this make sense?
#3? http://lathemaster.com/LATHEMASTER8x14Lathe.htm
Wayne D.
|