View Single Post
  #5   Report Post  
Posted to alt.home.repair
PHX PHX is offline
external usenet poster
 
Posts: 4
Default Changing media( resin) in a water softener


"hr(bob) " wrote in message
...
On Dec 15, 11:48 pm, "PHX" wrote:
"hr(bob) " wrote in message

...
On Dec 15, 2:32 pm, "PHX" wrote: Long story short I
think the resin is shot in a 12 + year old softener
that
sat unused for 10 years before being put into use.
At best the resign just may be inefficient compared to what is available
today.
ANy thoughts on what I need to know or do to change the resign?
Thanks


------------------------------------------------------------------------
You ought to be able to take a sample of the resin to a local water
testing lab and have them see what's happening.

Also, It might take a few cycles of use before the resin is fully
functional. Also, if the resin sat for that long, it make be caked
together, and a good stirring might separate the grains so they all
are working. It should have the consistency of fine sand. I would
take the exchange tank out of the softener and fill the exchange tank
with water and then try turning it upside down and maybe on its side
and rolling it around to loosen things up. Then cycle a few times and
see what happens. I have not heard of the resin dying just to old
inactive age.

------------------------------------------------------------------------

Its been a year of cycles, that is why i think there may be a problem. It
had not occurred to me that the resin could be caked together.
How do I remove the exchange tank...is this something separate from the
main
tank to which the head is attached( something that can be removed through
the top?
OR do I just take the head off and "shake " the whole tank up?

-----------------------------------------------------------------------
The exchange tank is about a foot in diameter and several feet tall.
It is the only tank insiide the whole softener. Any way to shake it
up ought to be tried. If you can get the head off, a long rod ought
to be able to stir things up. But, after a year of trying, I have to
feel not too optimistic that you will see much change, but if you can
save some $$$ it's worth trying.

Bob H
--------------------------------------------------------------------------

Ah, mine is a separate system, the exchange tank and mineral tank are two
units, fleck head.
my tank is about 48 inches tall or so.
I will take a look at it an see what I can "see"

Thanks