Bob Engelhardt wrote:
http://techtv.mit.edu/collections/ehs-videos/videos

Set of 10 videos, 30-40 minutes each. Beginner/novice level, but well
done. Better than some of the DVD's at SmartFlix & free.

I finished the whole series and found it very useful overall. Particularly
some of the work-holding ideas.
Until now I would not have contemplated using a double-sided sticky tape for
machining. Actually I did use it but what I did made the parts hot and the
tape loses grip very quickly then. Also it is a bugger to clean off...Still,
putting it on a giant six-jaw chuck jaw tips, sticking a big plate to it and
spinning it looked rather sporting!

--
Michael Koblic,
Campbell River, BC