Movement in worktop sink cutout
Hi,
I have just noticed that if I press down hard on my sink then the worktop at
the back moves by approximately 2mm. The worktop and sink were installed a
couple of weeks ago. At the back of the sink the worktop is about 4cm in
width.
Should I be worried about this movement?
Is 4cm too small and should I have moved the sink cut-out further from the
back of the worktop?
Will weakness appear over time leading to splitting of the 4cm strip?
I can get to the back from inside the sink base unit and could support this
4cm strip, but it is a pig of a job. Is it worth doing this?
This is the type of thing I lay awake at night worrying about!
John
|