Doh! Good catch Charlie :-) I meant to say 36" tape measure - if he slides
the rails to the right then all of his measurements will be off by n inches
(where n = the offset). A new tape glued in place of the old one would let
him use his original rails and cost very little to do...

--
Henry

To reply use henry @t henrywebb d0t com
---------------------------------------


"Charlie Self" wrote in message
...
Henry Webb responds:

y then you can unbolt the arms on the saw and slide
them to the right a foot, giving you a 36" rip capacity. You may then
have
to replace the gauge with one that's 36", but that should be realat

36" gauge?

Anyway, it MAY be possible for the OP to check on-line for a repair shop
nearby, and get that repair shop to order the fence rails for the 3612.

Might not, too, but worth a try, as it should be cheaper.

If not, www.mulecab.com is a good place to start looking for relatively
low
cost replacements.

Charlie Self

"Men willingly believe what they wish."
Julius Caesar, De Bello Gallico