Usually engineers have highly technical and complicated answers to simple
problems.
Tradesmen (that's me!) use wire nuts and lots of electrical tape.
--
Christopher A. Young
Learn more about Jesus
www.lds.org
..
"N8N" wrote in message
...
Engineer (by degree if not practicing) why?
nate
On Sep 13, 11:34 pm, "Stormin Mormon"
wrote:
Are you a surgeon, or an engineer?
"Nate Nagel" wrote in message
...
I would probably solder the individual wires together and cover them
with heat shrink, then wrap with friction tape then finally electrical
tape (or really big heat shrink if I had it)
if this is going to be used in a wet location, before sliding the heat
shrink over the splices, smear a little silicone grease on them to make
absolutely sure that no water can get in and corrode the wires.
nate