FYI...for the other person responding to this, the saw is 3hp, 240v,
single phase.

I am seeing 120v between L1/1 and ground. �And also 120v between L3/5
and ground. �However, I am most definitely NOT seeing any volts
between L1/1 and L3/5.

Jeff

From the information posted in this reply and if the saw wiring and
cable is wired correctly your/the source of power is 110 volts and/or
the receptacle that your cable is connected to is wired incorrectly.
Check the voltage at the receptacle where your saw is connected to. It
should NOT be a conventional 110 volt receptacle.

Bob AZ