Are you a surgeon, or an engineer?
--
Christopher A. Young
Learn more about Jesus
www.lds.org
..
Christopher A. Young
Learn more about Jesus
www.lds.org
..
Remove obvious spamblock to reply.
"Nate Nagel" wrote in message
...
I would probably solder the individual wires together and cover them
with heat shrink, then wrap with friction tape then finally electrical
tape (or really big heat shrink if I had it)
if this is going to be used in a wet location, before sliding the heat
shrink over the splices, smear a little silicone grease on them to make
absolutely sure that no water can get in and corrode the wires.
nate
nate
--
replace "roosters" with "cox" to reply.
http://members.cox.net/njnagel