"Mark F" wrote in message
news:FSBpk.8822$hx.7725@pd7urf3no...
Den wrote:
I want to try putting together a quick vacuum generator that runs off
compressed air (run of an 8 gallon tank up to 130 PSI.

I'll be using it for desoldering so I think I want a reasonably strong
vacuum, but the volume is not all that high. It will probably be used in
"burst mode" - with a burst of vacuum for a few seconds being needed
intermittently.

Heaps of googling and patent searching has turned up lots of commercial
products and on or two water powered vacuum generators but not much in
the way of pneumatic ones.

I'm hoping for a real quick & simple design - any build one or point me
to some plans?

thanks
D.
Well, having bought a "proper" solder / desolder station several years
ago, without vac pump, I sniffed around places like surplus center,
goldmine etc. and ended up with a small compressor, 12 volt, that
works a treat. Just get one that has a hook-uppable "suck" port.
This one is about C or D size battery, including motor.
Footswitch made it usable for those without 3 hands... /mark

Jeez - too many options! I've got a surplus little 12V compressor in my junk
pile, I'll go and pull the covers off and see whats inside. Did you use a
tank/reservoir or "turn on to suck"?
thanks