Thread
:
Electric Drill Bit Slippage
View Single Post
#
7
Posted to alt.home.repair
Jim Yanik
external usenet poster
Posts: 3,103
Electric Drill Bit Slippage
(Bill) wrote in
:
On Tue, 12 Aug 2008 05:18:07 -0700 (PDT), Edge
wrote:
I have a Craftsman 19.2 volt drill with a half inch chuck.
Keyed or keyless chuck?
Many times,
especially while pressing hard into the material being drilled, the
bit slips. No matter how much I tighten the chuck, the bit continues
to slip. Other than replacing the chuck, which isn't worth it, what
can be done? Is there a spray of some sort or something else to
provide a better grip on the bit.
What are you drilling? New or old bits? Are you using the right bits
for the job? Maybe dull bits are your problem.
put a heavy rubber band around the chuck to help get a better grip on it.
(for a keyless chuck)
he could grind 3 flats on the shank of the bits,with a Dremel.
Are the bit shanks all chewed up from slipping in the chuck? then you need
new bits.
also,maybe he's pressing TOO hard,forcing the bit thru the work.
--
Jim Yanik
jyanik
at
kua.net
Reply With Quote
Jim Yanik
View Public Profile
Find all posts by Jim Yanik