"Bob La Londe" fired this volley in news:g6q9v2$l97$1
@aioe.org:


Like rod stock? Where would I find rod stock that small?

Bob La Londe
www.YumaBassMan.com



Bob, if I were doing it, I'd make the pivot rod from some high-chromium
drill rod (virtually corrosion proof), and mount that in a clevis, rather
than forming the entire assembly from a single piece of wire.

But that's just me...

OTOH, if you're VERY careful, use heat-sinks around the area, and use a
tiny pencil flame, you can partially anneal just the sections of the
drill rod that require bending, and leave the working length full-hard.

LLoyd