|
|
can I stain over poly?
That is good news. It'll simplify things greatly.
Good luck.
--
Mike G.
Heirloom Woods
www.heirloom-woods.net
"bob" wrote in message
.. .
Good news on the demarcation line. The EC was built in two separate,
distinct sections with a face frame covering the joining. The face frame
is
fine. It's only the interior of the lower section that is lighter.
Thanks to all for great suggestions. Sure wish I didn't have to do
this...
Bob
"Mike G" wrote in message
...
As the replies already indicated there are ways to do the job. Which
ever
method you choose you are going to run into a few additional problems.
The first of which is that just adding a coat of tinted poly to the
light
area will leave you a demarcation line, sort of a self induced witness
line,
between the color coat and the existing coats. That line is going to
have
to
be feathered in and that is going to compound the problem of matching
the
darker part of the project. The next situation you could run into is
that
should, somewhere down the line, this color coat, being a top coat, get
damaged, repairing it will be difficult because not only will the color
coat
be damaged but there will be no way to repair the damage without
affecting
the color coat.
There are other ways to address the problem but, for simplicity's sake
I'd
suggest you apply you color coat up to the point needed then continue to
apply clear varnish to the rest of the project. I'd also suggest a
fourth
top clear coat over the whole thing to protect that color coat without
leaving any demarcation lines.
Too bad the situation wasn't reversed with the darker wood on the bottom
and
the lighter on the top. Most times you can get away with that sort of
thing
because it still looks balanced. Having the darker wood on the top sort
of
makes things look unbalanced and top heavy.
As an aside, I'd use an oil based aniline dye to do the blending rather
then
a stain or pigments/artist colors.
Just a thought
--
Mike G.
Heirloom Woods
www.heirloom-woods.net
"bob" wrote in message
. ..
Just finished putting two coats of oil based polyurethane on a red oak
entertainment center that was stained with Minwax gel stain. SWMBO
noticed
that the lower section of the entertainment center is lighter in color
than
the top. (It looked okay in the shop, but my lighting down there
isn't
the
greatest).
Question: Can I tint the poly and apply a third coat to the lower
section,
effectively darking it? Or, perhaps I can buy some stain/poly combo?
I
think I'd rather tint it so I can control the color.
I'm concerned that any type of stain over poly won't stick to the
poly.
Thanks.
Bob
|