Ivan Vegvary wrote:
Subject almost says it all.
Making a tube so I can splice two refrigeration hoses (manifold gauge hoses)
together since nobody is willing to sell me the needed fitting to my 30 lb.
bottle of R-134.
Start with 1/4" diameter by 2" long piece of air hardened steel. Put it in
3 jaw chuck. Drill full length with an 1/8" drill bit. Try to cram it into
the hoses, too big. Back into the 3 jaw, live center in tail stock, reduce
the diameter, flip it end for end and reduce the rest to match. Clean up
with a little piece of emery cloth. Project complete, except my hands are
filthy black.
Tools are relatively clean. Chuck key is pretty clean. 1/4" rod is brand
new. Why is machining so filthy? Does this happened to you guys also?
Seriously, I could do a brake job on my truck and only get half as dirty!!
What gives?
Ivan Vegvary
Stop doing warm-up cuts on graphite blocks.
--
Tim Wescott
Wescott Design Services
http://www.wescottdesign.com
Do you need to implement control loops in software?
"Applied Control Theory for Embedded Systems" gives you just what it says.
See details at
http://www.wescottdesign.com/actfes/actfes.html