Limp Arbor wrote in
:

On Jun 23, 10:31*am, "mozza" wrote:
in the process of bath room demo and remodel, job is almost completed
and
am
about to install a new toilet set

in looking at the floor connection where the waxring is seated and
lower section of toilet is attached, it is rather badly rusted.

is there something I may do before I attach the new toilet set, since
the drainline is now exposed and everything is clean and new? should
I consid
er
patching the ring/waxseal area with something like royal jelly? use
an ep
oxy
bond after sanding rust away? something else?

Depends on what you mean by badly rusted. If it is just the entire
surface is rusted that is common and nothing needs to be done. If it
is rusted through and crumbling then you need to replace the flange.


....and if it is badly rusted and weakened and you don't replace it, you
may find when you tighten the toilet down it bends up being pulled. Or,
later you may find the toilet rocks and you cannot tighten it.

NOTE NOTE NOTE. Remember to take the rag out of the ******** before
putting new toilet on! Murphy says rag will go way in to next elbow then
jamb and block.