On May 27, 5:54 am, RedDwarf wrote:
Hi folks,

I will be buying a prefab shed from lowes that is 12x16. It still has
to be assembled, I think they give you the frames built though. I was
curious to know how to attach the frames to the slab... I think they
assume the purchaser will be placing it on leveling blocks, and not on
a slab. (yes, I need the cement floor, i'll be running electrical to
it)

do I have to drill into it, can i liquid nail it (this may sound like
a stupid idea... i don't know)?

Thanks everyone.

It pretty much depends on what you are up against weather wise. I get
80MPH winds here occasionally, so I'd tie it down as well as possible.
On the other hand if high winds aren't a problem, one of those Ramset
type nail drivers likely would do. For the best hold down in an
existing slab, Concrete anchors epoxied into drilled holes are about
as good as it gets. They sell a 2 part epoxy at big box stores in
caulking gun tubes. Thats what I used for my 4 post lift, I've
regularly picked up 6000+ lbs, for years and it hasn't budged. I go
back and attempt to tighten the fasteners occasionally, and it has yet
to need it.