Preventing drill bit slippage
"Red Green" wrote in message
...
Jim Yanik wrote in
:
"John" wrote in
et:
I am using a 1/2" masonry bit in an old hammer-drill. At the
slightest catch, the bit slips, even to the point of coming out. It
uses the old screw thing to tighten.
I am thinking of grinding the bit up and down the bare spot. Any
other ideas?
John
replace the chuck with a new one.If the bit shank is damaged,get a new
bit.
Who woulda thought... :-)
Problem solved. I asked a friend and he told me to just grind a little bit
off three sides of the shank of the masonry bit. I did; it ground like
butter. And when the bit grabbed the material, it threw me against the
wall. Success!
John
|