Brent wrote:
Hey Guys

I had a mnor issue with an HVLP gun where i think i set the paint in
it to be too thick and as such i clogged up 3 of the 8 little nozzles
on the gun the tiny litttle ones near the central nozzle of an hvlp

How on earth do i get those cleaned or what is thin enough to get in
there? the holes are absolutely tiny sloshing the nozzle in laquesr
thinner didnt help me any nor did burying it in mineral spirits

Any ideas?

Time to spring six bucks or so for a set of drill bits, sizes 61 to
80. Get a couple cheap pin vises while you are ordering stuff.

Most of the usual suspects carry these sets.

A little carefull work with a drill bit smaller than the holes, and
work your way up to the drill bit that "just" fits the hole, and they
will still be round and clean.

The solvent to use is variable, depending on the paint. Using the
wrong stuff can turn some paints into mung that is similar to warm
chewing gum, and tough to clean out.

Paint stripper can be handy, too. Get the good stuff. If it won't burn
skin on contact, it isn't the good stuff!

Cheers
Trevor Jones