"BRG" wrote in message
...
snip

Have a look at the link below and that is what you need. You simply close
the door and then after cutting to size, lightly push the seal against the
door (starting at the top and working down) and screw the strip into
position. Screw, rather than nail it, because the holes are usually
elongated to give some adjustment during and after fitting if needed.

http://www.choiceful.com/choiceful-i...ound-17Ft.html

This stuff is usually available from any of the 'sheds' or local builders
merchants.

Remeber, the secret of this stuff is that it has to flex - so just push
lightly against the door so as not to deform the seal but enough to stop
the draught.

Hope it helps BRG.


Thanks for that - and thanks to everyone else for replying.

Excuse my ignorance, am I assuming correctly that this would go on the
outside of the door like Cicero mentioned? If so, that sounds like the best
plan and even I might not mess it up!

--
echo21