Thread
:
How to widen hole through wall header
View Single Post
#
14
Posted to alt.home.repair
Larry W
external usenet poster
Posts: 1,012
How to widen hole through wall header
wrote:
I need to widen a hole I made through 3 2x4's with 2 spade bits. I
made a hole with a 1" bit, then used a 3/4" bit next to it, so that it
overlapped just a bit. Unfortunately I started the second hole at an
angle, and by the time I got down into the last 2x4 the center was
almost into the original 1" hole, and the bit slipped over and
through. Now I have a V shaped hole that tapers too much to be of
use, and I don't know how to widen the hole so that the sides are
parallel.
If the appearance won't matter and it is accessible, try a hammer and chisel.
--
Often wrong, never in doubt.
Larry Wasserman - Baltimore Maryland - lwasserm(a)sdf. lonestar. org
Reply With Quote
Larry W
View Public Profile
Find all posts by Larry W