Thread
:
How to widen hole through wall header
View Single Post
#
2
Posted to alt.home.repair
Robert Allison[_2_]
external usenet poster
Posts: 256
How to widen hole through wall header
wrote:
I need to widen a hole I made through 3 2x4's with 2 spade bits. I
made a hole with a 1" bit, then used a 3/4" bit next to it, so that it
overlapped just a bit. Unfortunately I started the second hole at an
angle, and by the time I got down into the last 2x4 the center was
almost into the original 1" hole, and the bit slipped over and
through. Now I have a V shaped hole that tapers too much to be of
use, and I don't know how to widen the hole so that the sides are
parallel.
Anyone have any advice?
Thanks
Sounds like it is time to break out the sawzall. With just 3
2x4s, it won't be too much work.
--
Robert Allison
Rimshot, Inc.
Georgetown, TX
Reply With Quote
Robert Allison[_2_]
View Public Profile
Find all posts by Robert Allison[_2_]