I want to have a go at making some custom handlebar risers for a
motorbike. I'll be using 53mm dia' round bar but I'm having trouble
working out how to drill/bore the hole where the bars seat. It needs to
be split into 2 sections, the bottom section is fastened to the bike and
the top section clamps to this over the bars. The hole for the bars
needs to be approx 22mm (7/8ths) and will have to be reamed out for
accuracy.
If I drill the hole out first then cut it on a bandsaw I'm going to lose
the accuracy of the diameter with the width of the cut, I don't think
that my bandsaw will create an accurate enough cut anyway. Is it
possible to drill through the middle of two sections clamped together or
will I have to drill two holes in the stock, cut, then mate two sections
together?
http://tinyurl.com/yrlo5d