You first have to install an outdoor raintight extension box on to the
existing flush wall box, then you can use PVC, which is probably the neatest
thing to do, or if it's an old house with balloon framing you could snake
inside the wall from the existing box to the new location, or using approved
rain tight UF connectors, run sunlight resistant UF from the existing
location to the new location

"Robert11" wrote in message
. ..
Hello,

I plan on installing a flood light above my Deck.
There is presently a small outside light about six feet above the Deck, so
with the new floodlight
mounted about the height of the second story, we are talking a vertical
run
of perhaps ten feet or so. Would connect at the present small Deck light
box.

My first thought was to run the wire in the normal grey plastic conduit,
or
perhaps snake it inside the
wall, somehow.

But I realized that the normal house service 220 V wires run from the
vertical power line drop to the
inside of the house opposite the service box in the basement, so
apparently
it is code-compliant to run the correct type of
electrical wiring vertically on the outside of the house siding without
being in conduit.

The simplest thing would of course be for me to just run a suitable wire
against the siding on the outside, without any conduit.

What are the code requirements for this application (simple 110 V, 14 gage
wire) ?
I doubt that the regular NM-14 has an appropriate sheathing for this
application ?

What type of wire is code approved for this type of application, and what
would I want ?

Any caveats or not apparent or obvious Code requirements ?

I do have some NM wire approved for direcdt ground burial (per the label
on the box)
Sure does have a tough outer sheath.
Would this be O.K., perhaps ?

Whatever I do, i want to be 100% sure that it is Code compliant.

Much thanks, as always,
Bob