Meat Plow wrote in message
...
On Mon, 11 Feb 2008 16:09:24 +0000, N Cook wrote:

2 temp sensing things , one vaguely touching , the other bent away from
the
heatsink.
Perhaps every roadie should be put in a flight case and dropped down
some
stairs as a lesson.
Anyway both heatsinks must have bent relative to the pa pcb, bending the
leads.
How to anchor back more firmly than just white paste? The main TOP66
power
devices etc have those slide on spring steel clips but the loosened TO92
tranny and fan thermistor are a long way down from the mounting slots,
for
anything like that. Any ideas ? - live heatsink btw, hence not rigidly
held
to body.

Could you drill into the heatsink and make some sort of spring clip mount?
How about some duct tape Those sensors don't have to be driven into
the heatsink, just held against along with a little compound.


The band is off touring abroad from the end of the week. All I can think is
to secure bits of nylon cable tie to the pa pcb and bend up against the 2
errant items. Too crowded to drill/tap the heatsinks and the assembly of
these sort of hook-clip arrangements is realy make once,
dissamble/reassemble at your peril.

--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://home.graffiti.net/diverse:graffiti.net/