critique SMT pcb ?
hello,
This is the my 1st SMT pcb etching project board.
Is there anything horribly wrong with the layout of the
components and/or traces ?
Any advice on how to improve or fix the problems with the
layout/design etc... ?
The components are ;
IC is an SOIC-16 Quad OP amp and most of other components are
0805 and sot-23.
It is a two layer board where (red) traces are top of PCB and the
(green) is the bottom.
I was trying to lay out everything so that it would be a single
sided board. That is why there is a distinct lack of through
holes (VIAs)
thanks for any help,
robb
|