John A. Weeks III wrote:

In article ,
"Dan" wrote:

Correct me if I am wrong, but if the saddle valve was clogged, would
there not be any water making its way to the humidifier? The
problem is that the water is not being pushed up to the filter. Is
that the solenoid's function.

Any ideas? I don't want to waste money having a T-joint installed
if that is not the problem.

The solenoid is simply a water valve that is operated by an
electrical signal. When the humidity drops, the solenoid opens
and allows water to flow to the business end of the humidifier.
If the solenoid opens and you are getting little or no water
flow, the water line is plugged somewhere, but perhaps not
totally blocked, but blocked enough that have little or no
water pressure at the humidifier.

It first concerns me that the humidifier is tapped into
the hot water line. That opens you up to the problems with
scale in the hot water heater. I think it also would promote
the growth of bacteria.

Next, if you keep getting plugged up, I am far more concerned
about all this gunk getting into your food, drinking water,
and into your body. This goes double if you have lead solder
or lead pipes in the system. I think you want to consider
getting some water filters installed, and use an R/O system
in the kitchen for any water that goes into your food.

Finally, I think you do need to get a real water tap rather
than a saddle valve. Tap it off of the cold water. Then
clean out and back-flush the humidifier and any lines that
go to the humidifier. Finish it off by putting a sentiment
filter in the the line going to the humidifier.

You may also want to get your water tested. The gunk is
in your system for a reason. That reason might be that
you have hard or acidic water. You may need a softener
or a neutralizer. If you do have acidic water, it may be
that it is eating the pipes from the inside. If it is hard
water, you may have pipes that are getting build-up and
impacting your water pressure. All of these things are
bad for you plumbing system, and for your body. Get it
checked out before it causes any further health problems.

-john-

My water is hard. No doubt about it.

Honeywell recommends using the hot water side, but you can use cold
water. My GF has had a Honeywell humidifier for over 7 years without
any clogging. Her saddle valve is hooked up to the cold water side of
her water heater avoiding the tank sediment.

I loosened the compression nut that connects the copper tubing to the
solenoid. Water just dribbled out out of the copper tube with the
saddle valve fully open. I also found an inline mesh filter inside the
solenoid that I cleaned out. The water started flowing again, but it
stopped like before. I loosened the compression nut again with only a
dribble of water coming out.

I'm strictly an amateur, but I am guessing that there should be a free
flow of water coming out of the copper tube with the saddle valve fully
opened. Am I correct?




--