jusme wrote:
Trevor,

Are you having a bad day?

I said that I need two to three OR MORE FEET.

There is no specific length that I need other that what I specified above
this sentence. Make it 8 feet then, as is implied in "OR MORE".

You ASSume much without the benefit of fact, only guesses. I do not need to
reach down a deep hole.

Again, if you had REALLY read all of the posts, you would have discovered
that I didn't need a "long-reach" Torx bit. I said what I needed in the
very first post.

Also, I asked if anyone could give me some ideas on how to make such an
item/s. I got many great responses and ideas.
I DID NOT ask for a quote, as you seem to think.

Close to your last paragraph where you say that I am wanting some cheap-ass
tool, you again ASSume that I am trying to drive a screw in a deep hole.
Wrong yet again.

And no, I am not at liberty to give anymore information, as I stated, which
you would have known had you read the entire thread as you claim that you
did, when I said it is somewhat proprietary.

So, Trevor, rather than "around" and make ASSumptions, why not REALLY read
the entire thread before you 'go off'.


j/b
Thanks for that j/b, it pretty much leaves me feeling vindicated.
My conclusion is that you are just another nutbar inventor, too
brainlocked on a complicated way of getting to an end, to see that there
is a cheap and simple method to reach it.
So far, of all the guys I have dealt with that were inventing stuff,
you appear to be helping keep my experiences with inventors consistant,
anyways.
Any one of them would give the average machine shop operator shivers,
if they tried to become customers.
Headache. Capital H.

Good luck with the project.

Cheers
Trevor Jones