On Thu, 06 Dec 2007 13:43:29 -0800, lidiwhite wrote:

Please can someone help me!!! Tonight i was unable to lock my sliding
patio doors i had to lift the door of the runner because the top plastic
bolt bit had turned in the unit.. not sure on make of the doors but it
is a sliding door has plastic bit at top that locks into a hole and then
had four screws on side that lock into place with a push down handle and
key,,

The problem seems to be with the top bit it doesnt actually come out of
the door to go into the hole in the frame but stays within the door
itself and then when you unlock it it sits too low in the plastic casing
allowing it to turn freely into the wrong direction how can i get this
lifted so that it sits where it shoud be is there a screw i should
tighten somewhere


Please Help me

Thank you for your time

Lydia

Without seeing the lock, I can only guess.

It could be a broken or worn part within the lock.
It could also be accumulated dirt within lock thus preventing it from
moving freely.

If you are able, take lock apart, clean it and reinstall. Not as
difficult as you may think. Look for broken pieces on floor.