"Ignoramus11967" wrote in message
...
On 2007-11-17, Tom Gardner wrote:

Shush! Nobody's supposed to know that. The usual method of using wire
wheels is to press the workpiece harder into the under-powered,
under-revved, wrong trim length, wrong wire size, wrong diameter, wrong
width wire wheel. I'm convinced that less than 1% of people use a wire
wheel properly and I want to keep it that way! You're supposed to use a
brush once, destroy it and throw it away...then go buy a new one.

Tom, what would be a proper HP and RPM for a 8", 3/4" wide wire wheel?

i

What wire size? What trim? EG. my shop brush is 10" x 2" x .014" wire x 3"
trim and it's on a 2-1/2 HP (maybe a bit over-kill) 3600 rpm. An 8" x 3/4"
x .014" oil-tempered wire at 4500 rpm (or about 75% MSFS) with at least 1 hp
is a good GP set-up for most anything you will want to do. If it slows much
under load, not good. If you find you're pushing the work, not good, only
the wire tips do the work. DON'T CHANGE ROTATION!!! = early death! The
right set-up will last hundreds of hours. (PS...I sell to McMaster)