"James Sweet" writes:


Of course, there are a variety of standard thermistors that go for more
along the lines of $1 from an electronics distributor.

Does anyone know what the specs on this are?

Is it not in some special housing? I was envisioning a probe for sticking
into meat, perhaps this is just a cavity temperature sensor.

I'm not sure about that model, but the one I replaced a few years ago
was just soldered (or maybe spot welded) between two posts out in the open.

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.