"RBM" rbm2(remove wrote in message
...
From what you describe, your switch is wired to the neutral, and the hot
leg
goes directly to the fixture. It also sounds like you have an open circuit
on the neutral. With the switch on you should get a light between the hot
and neutral wires at the fixture. Open the switch box, wire the hot leg to
the switch and verify your neutral connections, which should just be
connected together under a wire nut



wrote in message
ups.com...
I had a fluorescent lighting fixture in my kitchen that would only
turn on, usually, with many attempt at the lighting switch. I decided
finally to replace the fixture, but it won't turn on at all. I have
found the "hot" wire in the ceiling box by using a continuity tester
with one probe connected to the hot wire and the other to a ground--
the tester glowed. The wall switch does stop and allow the current to
flow to the hot wire. Next I attached an incandescent bulb fixture
and bulb by attaching one wire of the incandescent fixture to the hot
wire in the ceiling box and the other fixture wire to the other
(neutral?) wire. The switch will not turn the incandescent bulb on.

My first question is whether there is a test to see whether the non-
hot wire in the ceiling (the putative neutral wire) is in good order?
Secondarily, if that is the wrong question, any suggestions?

Thanks in advance.



Also, change the switch.