DIYbanter - View Single Post - how to bypass dremel tool internal variable speed control?

krw

In article %AdNi.9074$Hb2.1737@trndny07,
says...

Well you need an air compressor for one of those, a tool relatively few
people own. I use a pneumatic die grinder occasionally, but it's louder
than
my Dremel and it spews out a bit of oil in use.

Sounds like you nead an oil trap next to your bench.

Well that would defeat the purpose of the oil in the first place, which is
squirted into the tool to lubricate the air motor. Perhaps you're referring
to the high speed air turbine tools? Either way unless you already have the
compressor as I did, an electric tool is far cheaper and is not tethered to
a big heavy noisy piece of equipment.

Tethered? I plumbed my house[*] for air. ;-)
[*] Places I'd likely use air tools.

--
Keith