Thread
:
FS- NICE cast iron surface plate
View Single Post
#
7
Gunner
Posts: n/a
FS- NICE cast iron surface plate
On 11 May 2004 02:14:11 GMT,
(Russ Wizinsky -
ProfessorWiz) wrote:
Ditto, how about somebody finding just loads of stuff around the East Coast or
better yet Michigan....... I'd love to junk the lathe I have and pickup
something I could actually use.
Russ Wizinsky
www.professorwiz.com
www.metalhobbies.com
Actually..there may be loads of stuff in Michigan. Im sure it all
didnt go into the scrap yards. It is the Rust Belt after all. You just
have to hunt it out.
Networking networking networking.
Anyone need an Axelson lathe? Its 48" by 122". Make you a good deal
on it G
How about a Eberhart 36" shaper? Mighty nice looking machine. I can
probably get it for less than $350. Its sitting under a tarp right
next to the 12" Prentiss-Reed Lathe. It will be cheap too G
Road trip!
Gunner
That rifle hanging on the wall of the working-class flat or labourer's
cottage is the symbol of democracy. It is our job to see that it stays
there.
- George Orwell
Reply With Quote