Thread
:
ballasts
View Single Post
#
2
Posted to sci.electronics.repair
Sam Goldwasser
external usenet poster
Posts: 244
ballasts
(G) writes:
I have a system that worked. Had a lamp and a ballast. It quit
working. I replaced lamp and ballast, check everything except the voltage
between the ends of the tube. The filiments light. My question, its a two
lamp ballast that has two unused wires. Having only one lamp connected,
could this cause a reduced starting voltage across the lamp. I am suspecting
some weak link and not a hard core problem.
Where are you located? What is your line voltage?
--- sam | Sci.Electronics.Repair FAQ:
http://www.repairfaq.org/
Repair | Main Table of Contents:
http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ:
http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites:
http://www.repairfaq.org/REPAIR/F_mirror.html
Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.
Reply With Quote
Sam Goldwasser
View Public Profile
Find all posts by Sam Goldwasser