"Terry G" wrote in message
news:SDimc.57672$Qy.46913@fed1read04...
I ended up plumping the welder into my 1/2" copper water line I used a few
years back for my sink. It is running directly behind the welder, and
with
a simple copper T, a sediment filter, and a valve with the proper fittings
(cost me exactly $20.00) I was able to supply the welder with constant 60
PSI of pressure. I run another hose with fitting into the drain. The
water
solenoid inside the welder works great. Not to worried about wasting
water
since I don't use the welder very often. And since it weighs 816 lbs, I
don't ever plan on moving it!

Terry

Good thinking, Terry. While different, that's about the same setup I use,
too. Works for me! No pumps to fail, and a steady supply of cool clean
water.

Harold