The design I started with came from www.runnerduck.com . Main difference
were the original was for a Delta drill press and mine is a Ryobi. I did use
a piece of MDF on the fence instead of 3/4" plywood. Plus I made my top a
bit bigger 12"x24" as opposed to 10"x16". If I was going to build it again
I'd do a couple of things different such as; notched the stiffener pieces to
fit under the lip of the metal table, and possible used MDF for all of it. I
may yet replace the fence with aluminum and add the stick on tape measures
from Rockler.

Mike
Watch for the bounce.
If ya didn't see it, ya didn't feel it.
If ya see it, it didn't go off.
Old Air Force Munitions Saying
"Bob the Tomato" wrote in message
...
On Sun, 2 Sep 2007 17:13:22 -0600, "asmurff"
wrote:

I just finished one of my first projects in many many years, a larger
table for my drill press.





The original plans came from Runner Duck (thank you) and were modified to
fit my drill press. One question should I put some sort of finish on it
or leave it bare.


Mike
Watch for the bounce.
If ya didn't see it, ya didn't feel it.
If ya see it, it didn't go off.
Old Air Force Munitions Saying


Good job! There have been several of these designs in magazines
recently... which one did you build, or was it your own design?
Anything you'd do differently?

Bob the Tomato