Can I heat bend a one inch grey plastic electrical 90 degreebend?
terry wrote:
On Aug 30, 1:46 am, Big_Jake wrote:
OK, I gotta ask, why would you want to do this?
Knew somebody would eventually ask!
It's an attempt to make a compact J bend to go through the deck of
sailboat near the bottom of the mast through which to take the wires
from the mast into the boat; where they will connect to a terminal
strip.
....
If you get the bend, how you going to do the pull? Sounds iffy...
I'm thinking in terms of a watertight access cover w/ rear entrance on
one end and 90 on the other? Don't know if can find one w/ both
entrance/exit as rear or not...
--
|