I don't know exactly for the model you have, but I can suggest generically
from servicing these types of units. This may be a failure on the input
processor board in the projector. The procedure is to swap out the board to
verify this. If so, then leave the good board in the unit, and dispose of
the old one.

Many of these devices do not have an internal way to enter the service mode.
They use an external PC interface with the manufacture software to get in to
the service mode. It is very rare that the service mode is required. When a
fault occurs it is usually a failed component. Service on these units is
done by board exchange. There is very little component level service
supported with these devices.


--

JANA
_____


wrote in message
oups.com...
Hello,

is there a way to enter the service mode for the Hewlett-Packard
projector vp6100?
If so, how do I enter it?

Greetings,

Hendrik Hanff