On Wed, 20 Jun 2007 00:26:21 -0400, the renowned Chuck Harris
wrote:

Hi,

Does anyone have a favorite, readily available, dual opamp with the following characteristics:

1) single supply
2) output swings to either rail
3) input swings to gnd
4) 1458 pin out
5) low offset and drift


and most importantly,

6) well behaved (no latch up, spurious oscillations, ...)

Basically, I need a better 1458. Speed and slew rate are of
no real consequence.

I've been looking for one, and the selector guides just don't seem to
work very well.

Thanks!

-Chuck

LT1013 meets most of your specs (output doesn't swing very close to
the positive rail ,and input CM range also does not include the
positive rail).

Most of the R-R op-amps won't handle very high supply voltages- eg.
LMV822 can only handle 5.5V from + rail to - rail (so +/-3.3 is too
much for it).


Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com