Minimal bottom nib
On Mon, 23 Jul 2007 14:46:26 -0400, BillinDetroit
wrote:
mac davis wrote:
On Sun, 22 Jul 2007 22:39:37 -0400, BillinDetroit
wrote:
I was hoping I'd overlooked something. An inch and a half Forstner into
a small piece (no two alike so fixturing is 'iffy') might make for an
interesting work holding exercise.
I wanted to avoid that.
Bill
What size stuff are you drilling into, Bill?
Small enough to chuck in the lathe, or larger?
mac
A range of about 4" to 6" for use with those tiny little oil lamps.
Bill
Ok... too big for the lathe unless you have a real big chuck.. *g*
I usually use the center finder and punch on 'em (you probably have done that
already) and put a bar clamp on them, then clamp the bar clamp to the DP table
with spring clamps..
mac
Please remove splinters before emailing
|