Lew Hodgett wrote:
BillinDetroit wrote:

Am looking for a way to make a 1 1/2" dia. hole, ~1 1/2" deep with
minimal bottom indentation (flat-bottomed hole). I have a 1/2 hp drill
press and a 3/4 hp lathe.

How many ways can you say "Forstner bit"?

Lew



I was hoping I'd overlooked something. An inch and a half Forstner into
a small piece (no two alike so fixturing is 'iffy') might make for an
interesting work holding exercise.

I wanted to avoid that.

Bill


--
I'm not not at the above address.
http://nmwoodworks.com


---
avast! Antivirus: Outbound message clean.
Virus Database (VPS): 000758-3, 07/22/2007
Tested on: 7/22/2007 10:39:39 PM
avast! - copyright (c) 1988-2007 ALWIL Software.
http://www.avast.com