Am looking for a way to make a 1 1/2" dia. hole, ~1 1/2" deep with
minimal bottom indentation (flat-bottomed hole). I have a 1/2 hp drill
press and a 3/4 hp lathe.

38 mm is also acceptable.

I want to make the hole in one pass. This is not a critical appearance
item but, of course, better is better.

What is my best choice of drill bit and who, if you know, has them for
yesterday delivery?

Bill
--
I'm not not at the above address.
http://nmwoodworks.com


---
avast! Antivirus: Outbound message clean.
Virus Database (VPS): 000758-3, 07/22/2007
Tested on: 7/22/2007 7:54:46 PM
avast! - copyright (c) 1988-2007 ALWIL Software.
http://www.avast.com